FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1756 total: showing 181-200)

To prepare the molecular sieve, how many grams are needed per bottle?
Which countries can the molecular sieve be shipped to?
Why did Campbell Scientific start using a molecular sieve? Does it have the same effect as the previously used chemicals?
Can a molecular sieve be used in the future to replace bottles for gas analyzers sold before July 2017?
What might cause a battery to not hold its charge?
If a CS110 electric field sensor is installed in complex terrain, such as on a ridgeline in alpine territory, what is the effective range (spatial range) of the instrument, and how might it differ from a flatland site?
Does the CR1000X have a Thermistor() instruction similar to the CR6?
In the event that the CR1000X becomes damaged and needs a new wiring panel, what should be done?
How does the power usage of the CR1000X compare to the power usage of the CR1000 or CR6?
Can a program written for a CR1000 be used on a CR1000X?
Can a CS320 be calibrated to a smaller range to measure only PAR (photosynthetically active radiation)?
How can the CS320 be mounted if the 18356 leveling base is not used?
Is it possible to read the output from a CS320 in a 4 to 20 mA form?
On routine site visits, how can the calibration of the CS320 be checked?
How often does the CS320 need to be recalibrated?
What is the difference between a thermopile pyranometer and a silicon photocell pyranometer?
How can an end user simulate a lightning strike to an SG000 or CS110?
How many AM16/32B multiplexers can be connected to a data logger at the same time?
Which weather measurements are needed when calculating reference evapotranspiration?
If a CH200 or PS200 is hooked up to both solar and ac power supplies, which power supply does the device use?

Previous Next